Thermistor and wire

Reference: EPCOS100K

Condition: New product

Thermistors reading temp : resistance across which changes with temperature.

PRE ORDER

$1.70

  No tax

Paiement CB et Paypal
Paiement CB et Paypal

Volume discounts

Quantity Discount You Save
5 10% Up to $0.85

Data sheet

Version NTC100K - Pearl

More info

Thermistors are resistors, the resistance across which changes with temperature.

By reading that resistance, a board like the Smoothieboard can evaluate the temperature of a hotend or heated bed, and decide to heat it, or to stop heating it, using one of it's mosfets.

This thermistor, the EPCOS100K, is probably the most common for DIY digital fabrication machines. It's commonly used on hotends, but is also adequate for heated beds.

You can find documentation on how to configure Smoothie to control temperatures here : http://smoothieware.org/temperaturecontrol

The Smoothieware firmware defaults to using the EPCOS100K in it's configuration, so if you use this thermistor, you do not need to specify one.

This thermistor comes pre-wired with PTFE sleeves and a 1 meter-long cable.

You can find technical details in the datasheet located here : en.tdk.eu/inf/50/db/.../Glass_enc_Sensors__B57560__G560__G1560.pdf

Reviews

No customer reviews for the moment.

Write a review

Accessories